TurnerCIP
TurnerCIP (Clean In Place)
Clean In Place Systems For Oil In Water Monitors
Most oilfield produced waters and other oily waste waters have high fouling potential for 
optical sensors. High Cost Ultrasonic Cleaning systems only address the local optical path and not the entire sample system. Our CIP (Clean In Place) addresses the entire sample system in the same way that CIP’s are used to clean heat exchangers and other oily systems.
- Chemically cleans the complete sample system from sample take off to the drain from the monitor.
- Self Contained with no chemical discharge while cleaning. All chemicals and waste are self contained until drained.
- Pneumatic or Electrical, Manual or Automated, Explosion Proof or General Purpose. Can be fully controlled by TD-4100 XD with E09.
- Chemical choice and cleaning frequency dependent on the process water.
- Light weight / small footprint
- Can be used to clean multiple sample lines with one CIP.
- Add to any existing oil in water monitor
- Lowest cost of ownership. Can be manufactured locally with free supplied drawings.
With our over 20 years of success in produced water, it is well known that making the measurement is only the beginning. Maintenance is the problem! No matter how you cut it, oil in water analyzers are faced with problems and there are no two locations alike! Scale, solids, wax, iron sulfide, crude oil lead the list of foulants.
You take care of them, they take care of you. The problem is that nobody wants to maintain oil in water monitors. And, there is no such thing as Zero Maintenance. Zero maintenance is a myth. Ultrasonic cleaning systems are great. But except in a few cases, they do not solve the whole problem. Ultrasonic systems for oil in water monitors were developed because customers wanted an optical device that was in contact with the water at all times. Everyone knows that dirty, oily water will eventually foul optical surfaces. However, ultrasonic systems are localized to the optical windows or cell and they do not address the sample system. Further, start/stop action of systems with ultrasonics can make things worse by letting sediment settle or foulants plate out on the tubing/piping. Falling stream non-contact systems work great until the sample systems foul and reduce the sample flow.
A self contained chemical cleaning system that can be manual or automatic, pneumatic or electrical. All chemicals are returned to the supply tank for recycle on the next cleaning cycle. Customers report up to 12 months of use before refreshing chemicals. The specific chemicals and cleaning cycle time are determined based on the needs of the facility and the fouling potential of the produced water.
Click below for view/download product details
